Sakura HBK-18?23AB Manual de Instruções

1 Modular Locomotive System HBK18 Katie R/C Fittings Only Kit Instruction Manual Roundhouse Engineering Co. Ltd. Units 6-9 Churchill Business Park. C

10 Reversing Servo Push Rod Connection 1 - Starlock washer. 2 - Pushrod connector. 3 - Lock screw Fit a push rod connector as shown in diagra

11 screws. This has now set the servo horn for mid gear and moving the control lever either way will move the horn accordingly. Set up the transm

12 A replacement r/c type regulator is supplied with this kit. Although externally it looks the same as the manual type supplied w

13 Regulator Push Rod Connector 1 - Clamp screw. 2 - Push rod connector. 3 - Starlock washer. Prepare a servo horn with a sin

14 supplied linkage, Quicklink and lock nut, connect the regulator arm to the servo horn as shown in diagram 3. First pass the plain end of the

15 This is because the '0' ring will compress slightly into its seat when fully closed. You may need to adjust the position of the arm on th

16 HBK18 Checklist for Katie R/C Fittings Only Kit 1 Etched brass chassis cover plate 1 Etched brass battery box 1 Plastic battery holder (4 x

2 HBK18 Katie R/C Fittings Kit Introduction These instructions cover the fitting of radio control to the HBK15/16/17 ‘Katie’ 0-4-0 locomot

3 Construction Folding battery box and chassis cover plate. First of all, fold up the etched brass battery box and chassis cov

4 The locomotive body should first be removed to allow installation of the radio control equipment. Reversing Servo 1 - Reversing servo-moun

5 mounting post with a plastic cable tie, and then passed down through the small rectangular hole to the left of the boiler. Do not fit the horn or l

6 the foot plate (which you fitted during the body construction). The servo is passed through the rectangular hole in the bracket from the

7 connected together. Two short lengths of the small diameter shrink-wrap about ½" (13mm) long should be cut from the 2” (5 cm)

8 Chassis Cover Plate Plug the regulator servo lead into channel 2 on the receiver and the reversing servo lead into channel 1. All loose

9 large flap fits up between the frames behind the rear wheels. When in place this cover boxes in the rear portion of the chassis - see pic