Sakura HBK-18?23AB Manual de Instruções descarregar pdf (Página 11)

screws.

This has now set the servo horn for mid gear and moving the

control lever either way will move the horn accordingly.

Set up the transmitter, using the servo reversing switch if

necessary, so that moving the lever to the left engages

forward gear (moves horn forwards) and to the right engages

reverse (moves servo horn to the rear).

Using the reversing control rod already fitted or the longer of

the two rods provided, slide the straight end through the cross

hole in the push rod connector.

Connect the Quicklink connector into the hole in the lifting arm

by springing open the end of the Quicklink and passing the pin

through the hole in the top of the lifting arm.

Now, check for movement to full gear in both directions and

make fine adjustments to the linkage by moving the rod in the

push rod connector until the radius rod moves an equal

amount both up and down the expansion slot.

Note that the radius rod should not travel the full length of the

expansion link, but should stop a small distance from either

end.

On some transmitters there is an extra refinement to aid us in

this setting in the form of three extra ‘trimmers’. The left hand

one labelled ‘Throttle Quick Trim’ can be ignored, as this now

has no function. The other two, labelled ‘CHI ATV CH2’

control the amount of rotation of the two servo spindles and

‘CH 1’ can therefore be used to adjust the maximum raising

and lifting of the radius rod.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Sakura HBK-18?23AB Manual de Instruções Página 11