Sakura HBK-18?23AB Manual de Instruções descarregar pdf (Página 12)

A replacement r/c type regulator is supplied with this kit.

Although externally it looks the same as the manual type

supplied with the boiler kit, internally it is quite different. It is

designed to operate with a servo where a small amount of

movement must give full control from closed to fully open. It

also relies on a '0' ring to ensure that it closes fully with the

minimum of force.

Although the standard needle valve supplied with the boiler

can be used with radio control, its operation, particularly in

closing fully, is not always reliable.

Fitting of the r/c type regulator to the boiler is the same as for

the manual type and is described fully in the boiler kit

instructions.

Prepare the regulator arm by first bending the regulator arm

as shown in the picture opposite. This will allow the regulator

control rod to connect the regulator servo horn to the regulator

arm, in a straight line.

Fit the push rod connector to the fourth hole with the centre

boss of the arm and the push rod connector both on the same

side. Push the spigot through the hole from the front and push

the Starlock washer over the spigot to lock it on. Fit the screw

in the end of the connector loosely. See picture opposite.

Set the left hand control lever on the transmitter to the bottom

and ensure that the trimmer at the side of it is at the top. This

will park the servo in its normally closed position.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sem comentários

Sakura HBK-18?23AB Manual de Instruções Página 12